Cisco 10008 Quick Start Manual page 30

Use the following procedure to connect a video terminal to the console port on a PRE:
Figure 23 Console Port Connection on the PRE
Connect one end of the RJ-45 crossover cable to the serial RJ-45 port (CONSOLE) on the PRE.
Step 1
Run the cable up and through the cable-management bracket and connect the other end of the RJ-45 crossover cable
Step 2
to the RJ-45 adapter (Figure 24). If your terminal is equipped with a DB-25 serial connector, use the RJ-45-to-DB-25
adapter. If your terminal is equipped with a DB-9 serial connector, use the RJ-45-to-DB-9 adapter.
Figure 24 Connecting an RJ-45-to-DB-9 Console Cable Adapter
Connect the adapter to your video terminal to complete the cable connection.
Step 3
Power on your video terminal.
Step 4
Configure your video terminal to match the following default console port settings:
Step 5
• 9600 baud
• 8 data bits
• No parity generation or checking
• 1 stop bit
• No flow control
30
C IS C O
1 0 0 0 0