Table of Contents
Advertisement
INTELLIDOX DOCKING MODULE
Mounting Individual Modules on a Wall
1.
Prepare the modules for mounting.
a)
b)
c)
2.
Detach the back panel.
a)
b)
c)
3.
Mark the position of the anchor points on the wall, and then drill the holes.
a)
b)
c)
4.
Secure the panel to the wall with the metal brace facing out. Use appropriate hardware for
each of the 4 anchor points. Do not overtighten.
5.
Attach the module to the mounted back panel.
a)
b)
6.
Prepare the module for use. For more information, see Prepare Modules for Use.
a)
b)
Removing an Individual Module from a Mounted Back Panel
1.
Disconnect the power cord, network cable, tubing and inlet filter assemblies.
2.
Find the panel latch at the top right side of the module, near the panel hinge.
3.
Press down firmly on the panel latch, and then continue to press down while you push the
module to the right until the hinge pins and hooks are detached. Remove the module.
HONEYWELL
Disconnect modules that are connected into groups.
Disconnect the power cord, network cable, tubing and inlet filter assemblies.
Remove the end plate.
Hold the module with the back panel facing toward you.
Find the panel latch at the top left side of the module, near the panel hinge.
Press down firmly on the panel latch, and then continue to press down while you
slide the panel to the right until the hinge pins are detached.
Hold the panel against the wall in the desired position.
Use a pencil or non-permanent marker to mark the center of the 4 anchor points,
and then set the back panel aside.
Drill through the center of each anchor point mark.
Align the hinges and hook receptacles on the module with the hinge pins and
hooks on the mounted panel.
When the module lies flat against the mounted panel, push it firmly to the left to
lock it onto the panel.
Attach the end plate. Verify that the latch arm is lowered and locked.
Connect the inlet filters, tubing, network connection and power cord.
USER MANUAL || ASSEMBLE MODULES
PAGE 19 OF 119
Advertisement
Table of Contents
