Installing The Handle; Removing The Mulching Plug; Installing The Grass Basket - Makita DLM432PG2 Instruction Manual

Installing the handle

NOTICE:
When installing handles, position the
cords so that they are not caught by anything
between the handles. If the cord is damaged, the
mower switch may not work.
1. Slide the both ends of lower handle into the grooves
of the mower then fully tighten the clamping screws.
1
► 1 . Clamping screw 2. Lower handle
2. Align the screw holes of upper handle and lower
handle. Secure them with the clamping screws and
nuts.
2
1
► 1 . Clamping nut 2. Clamping screw
NOTE: Hold the upper handle firmly so that it does
not drop off your hand.
3.
Attach the holders to the handle. Position the
power supply cord as shown in the figure.
► 1 . Holder
2
1

Removing the mulching plug

Optional accessory
1. Open the rear cover.
► 1 . Rear cover
2. Hold the mulching plug by the handle, and then
pull it out from the mower body as shown in the figure.
2
► 1 . Mulching plug 2. Handle
2

Installing the grass basket

1. Open the rear cover.
► 1 . Rear cover
7 ENGLISH
1
1
1