Overload Protection; Overheat Protection; Overdischarge Protection - Makita DLM432PG2 Instruction Manual

Cordless lawn mower
Table of Contents

Advertisement

3.
Insert the lock key in the place shown in the figure
as far as it will go.
► 1 . Lock key
4.
Close the battery cover and push it until it is
latched with the locking lever.
To remove the battery cartridge from the mower;
1.
Slide the battery cover locking lever and open the
battery cover.
2.
Pull out the battery cartridge from the mower while
sliding the button on the front of the cartridge.
3.
Pull out the lock key.
4.
Close the battery cover.
Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend tool and battery life. The
machine will automatically stop during operation if the
machine or battery is placed under one of the following
conditions.

Overload protection

When the machine is operated in a manner that causes
it to draw an abnormally high current, the machine
automatically stops without any indication. In this situ-
ation, turn the machine off and stop the application that
caused the machine to become overloaded. Then turn
the machine on to restart.

Overheat protection

When the machine is overheated, the machine stops
automatically. Let the machine cool down before turning
the machine on again.

Overdischarge protection

When the battery capacity becomes low, the machine
stops automatically. If the product does not operate
even when the switches are operated, remove the bat-
teries from the machine and charge the batteries.
Indicating the remaining battery capacity
1
► 1 . Battery indicator
When the remaining battery capacity gets low, the battery
indicator blinks on the applicable battery side. By further use,
the machine stops and the battery indicator lights up about
10 seconds. In this situation, charge the battery cartridge.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► 1 . Indicator lamps 2. Check button
Press the check button on the battery cartridge to indicate the remain-
ing battery capacity. The indicator lamps light up for a few seconds.
Lighted
9 ENGLISH
1
1
Indicator lamps
Off
Blinking
2
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dlm432Dlm382Dlm382pm2Dlm382ct2Dlm432z

Table of Contents