Iso 15693 Instructions; Afi - Application Family Identifier; Bs - Block Size; Gms - Get Multiple Block Security - AEG ARE i2 - HF Installation Manual

5.6

ISO 15693 instructions

5.6.1 AFI – application family identifier
With this command you can change the application family identifier of the reader. The reader reads only
transponders, with the same application family identifier as the reader. If the application family identifi-
er is set to 00h the reader reads each transponder.
Input format:
Output (example):
Parameter:
PARAMETER
00
01h..FFh
5.6.2 BS – block size
With the command BS you can choose the block size of the used transponder. If the ISO 15693 tran-
sponders support the "get system information" command, the parameter BS is not used. Only if there is
no information of the block size of the transponder available, the parameter regulates the reading pro-
cess. The block size is defined in the ISO 15693, e.g. parameter 00H means the blocksize is 1 byte.
Input format:
Output (example):
PARAMETER
00h..1Fh
5.6.3 GMS – get multiple block security
This commands shows if one/multiple blocks of a transponder are locked or not. You have to do a get tag
first.
--------------------------------------------------------------------------------40/50--------------------------------------------------------------------------------
AFI <SP> parameter <CR>
00 <CR>
FUNCTION
every transponder is read
just transponders with the
same application identifier are
read
BS <SP> parameter <CR>
00 <CR>
FUNCTION
1 byte..32bytes