Specifications; Intended Use - Makita DF001G Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Drilling Steel
capacities
Wood
Fastening Wood screw
capacities
Machine screw
No load speed High (2)
(RPM)
Low (1)
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
WARNING:
and chargers may cause injury and/or fire.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
DF001G
20 mm
Auger bit: 50 mm
Self-feed bit: 76 mm
Hole saw: 152 mm
10 mm x 90 mm
M6
0 - 2,600 min
0 - 650 min
181 mm
D.C. 36 V - 40 V max
2.7 - 3.3 kg
BL4020 / BL4025 / BL4040 / BL4050F
DC40RA / DC40RB / DC40RC
Only for EU countries
Ni-MH
Li-ion Due to the presence of hazardous com-
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Do not dispose of electrical and electronic
appliances or batteries with household
waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and on accumulators and batteries
and waste accumulators and batteries,
as well as their adaptation to national law,
waste electrical equipment, batteries and
accumulators should be stored separately
and delivered to a separate collection point
for municipal waste, operating in accor-
dance with the regulations on environmen-
tal protection.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.

Intended use

The tool is intended for drilling and screw driving in
wood, metal and plastic.
4 ENGLISH
-1
-1