Honeywell SRX2 User Manual page 46

Hide thumbs Also See for SRX2:
Table of Contents

Advertisement

SRX3 User Guide - Preliminary
headsets
at your
site:
NOTE
If the device state indicator blinks red, the NFC read was not successful,
and you should attempt to perform the read again .
You only need to pair the device to the headset electronics module:
If you are
not
sharing
headsets
at your
site:
NOTE
If the device state indicator blinks red, the NFC read was not successful,
and you should attempt to perform the read again.
Using TouchConnect to Obtain
Operator Information from the
Headband
(headband) with the
of the raised oval on the side of the device
with the
symbol, until the device state
(ring) indicator blinks green. This
associates the operator's headband to the
device enabling VoiceConsole to
recognize the operator.
2. Touch the side of the A700/A700x device
that has the
symbol and the oval area
of the headset's keypad section together,
aligning the ovals on each and holding
them together steadily, until the device
state (ring) indicator blinks green. Note
that there is a 30-second timeout after a
headband is recognized in step one. You
must pair the electronics module within
30 seconds from associating the
headband for full functionality.
1. Touch the side of the A700/A700x device
that has the
of the headset's keypad section together,
aligning the ovals on each and holding
them together steadily, until the device
state (ring) indicator blinks green.
Using TouchConnect to Pair an
SRX2 or SRX3 with an A700 or
A700x Device
symbol to center
symbol and the oval area
40

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srx3

Table of Contents