Removing The Electronics Module From A Headband; Srx2/Srx3 Headset Compatibility; Srx3; Srx2 - Honeywell SRX2 User Manual

Removing the Electronics Module from a Headband

1. Grasp the electronics module with one hand, pressing your thumb and
2. With the other hand, hold the headband by the earpiece hub.
3. Pull the electronics module away from the earpiece hub.

SRX2/SRX3 Headset Compatibility

SRX3

Honeywell has tested the SRX3 Wireless Headset with the following devices and Vocol-
lect Voice Software versions. Support and compatibility of the SRX3 headset is not lim-
ited to these products, but the customer assumes risks related to untested
configurations.
Device
Vocollect Talkman A700x
Vocollect Talkman A700
Vocollect Talkman A500
The SRX3 Headset requires Honeywell Accessory Update utility v3.0 or greater.

SRX2

Honeywell has tested the SRX2 Wireless Headset with the following devices and Vocol-
lect Voice Software versions. Support and compatibility of the SRX2 headset is not lim-
ited to these products, but the customer assumes risks related to untested
configurations.
13
IMPORTANT
Do not squeeze the battery latches on the sides of the electronics module
while removing it from the headband. The battery may be inadvertently
released from the electronics module.
Do not remove the electronics module by pulling on the microphone boom
as this may cause damage.
fingertips into the gap between the electronics module and earpiece hub.
Vocollect Voice Software
VoiceCatalyst 4.0 and newer
VoiceCatalyst 2.4 and newer
VoiceCatalyst 2.4 and newer
SRX3 User Guide - Preliminary