Optional Accessories - Makita DLS110 Instruction Manual

45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
Fig.74
If the pointer does not indicate the 45° position, align
opposite side of the bevel angle scale.
Fig.75: 1.
ing bolt
Adjusting the laser line position
For DLS111, DLS112 only
WARNING:
The batteries must be installed
while adjusting the laser line. Take extra care not
to switch on the tool during adjustment.
CAUTION:
Never look directly into the laser
beam. Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE:
Check the position of laser line regu-
larly for accuracy.
NOTICE:
Beware that impacts to the tool. It may
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE:
Have the tool repaired by a Makita autho-
rized service center for any failure on the laser unit.
procedures to alter the laser line position.
1. Remove the batteries.
2. Draw a cutting line on the workpiece and place it
piece with a vise or similar securing device.
3. Lower the handle and align the cutting line with
the saw blade.
4. Return the handle to the original position and secure
the workpiece with the vertical vise so that the workpiece
does not move from the position you have determined.
5. Install the batteries and turn on the laser switch.
6.
Adjusting the laser line on the left side of the blade
Fig.76: 1.
3. Hex wrench 4. Laser line 5. Saw blade
Adjusting the laser line on the right side of the blade
Fig.77: 1.
3. Hex wrench 4. Laser line 5. Saw blade
7.
laser line comes onto the cutting line and then tighten.
2.
-
2.
2.
NOTE:
Cleaning the laser light lens
For DLS111, DLS112 only
light gets dirty. Clean the lens for laser light periodically.
Fig.78: 1. Screw 2. Lens
Remove the batteries. Loosen the screw and pull out
the lens. Clean the lens gently with a damp soft cloth.
-
NOTICE:
Do not remove the screw which
secures the lens. If the lens does not come out,
loosen the screw further.
NOTICE:
Do not use solvents or any petro-
leum-based cleaners on the lens.
After use
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
tions with machine oil to prevent rust.
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
WARNING:
attachments are recommended for use with your
any other accessories or attachments may result in
WARNING:
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
NOTE: Some items in the list may be included in the
differ from country to country.
35 ENGLISH
These Makita accessories or
Only use the Makita accessory
-