Makita DLS110 Instruction Manual page 31

WIRELESS ACTIVATION
FUNCTION
For DLS111 only
What you can do with the wireless
activation function
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
Fig.58
ing items:
activation function
as follows. Refer to each section for detail procedures.
1. Installing the wireless unit
2.
3. Starting the wireless activation function
Installing the wireless unit
CAUTION:
surface when installing the wireless unit.
NOTICE:
Clean the dust and dirt on the tool before
installing the wireless unit. Dust or dirt may cause
malfunction if it comes into the slot of the wireless unit.
NOTICE:
To prevent the malfunction caused by
static, touch a static discharging material, such
as a metal part of the tool, before picking up the
wireless unit.
NOTICE:
When installing the wireless unit, always
be sure that the wireless unit is inserted in the cor-
rect direction and the lid is completely closed.
1.
Fig.59: 1. Lid
2. Insert the wireless unit to the slot and then close
the lid.
with the recessed portions on the slot.
Fig.60: 1. Wireless unit 2.
4. Recessed portion
When removing the wireless unit, open the lid slowly.
as you pull up the lid.
Fig.61: 1. Wireless unit 2. Hook 3. Lid
case or a static-free container.
NOTICE:
Always use the hooks on the back of
the lid when removing the wireless unit. If the
hooks do not catch the wireless unit, close the lid
completely and open it slowly again.
Tool registration for the vacuum
cleaner
NOTE:
registration.
NOTE: Finish installing the wireless unit to the tool
before starting the tool registration.
NOTE: During the tool registration, do not pull the
-
switch trigger or turn on the power switch on the
vacuum cleaner.
NOTE: Refer to the instruction manual of the vacuum
cleaner, too.
If you wish to activate the vacuum cleaner along with
-
tion beforehand.
1.
tool.
2.
Fig.62: 1. Stand-by switch
3.
uum cleaner for 3 seconds until the wireless activation
vation button on the tool in the same way.
Fig.63: 1. Wireless activation button 2. Wireless
If the vacuum cleaner and the tool are linked success-
fully, the wireless activation lamps will light up in green
for 2 seconds and start blinking in blue.
NOTE:
in green after 20 seconds elapsed. Press the wireless
activation button on the tool while the wireless acti-
vation lamp on the cleaner is blinking. If the wireless
activation lamp does not blink in green, push the wire-
NOTE: When performing two or more tool registra-
tion one by one.
Starting the wireless activation
function
NOTE: Finish the tool registration for the vacuum
cleaner prior to the wireless activation.
NOTE: Refer to the instruction manual of the vacuum
cleaner, too.
3. Lid
vacuum cleaner will automatically runs along with the
switch operation of the tool.
1.
2.
tool.
Fig.64
3.
Fig.65: 1. Stand-by switch
31 ENGLISH
Install the batteries to the vacuum cleaner and the
Set the stand-by switch on the vacuum cleaner to
Press the wireless activation button on the vac-
activation lamp
Install the wireless unit to the tool.
Connect the hose of the vacuum cleaner with the
Set the stand-by switch on the vacuum cleaner to
-
-
-