Maintenance; Adjusting The Cutting Angle; Miter Angle - Makita DLS110 Instruction Manual

State of abnormality
along with the switch operation of
the tool.
tool's switch trigger is not pulled.

MAINTENANCE

WARNING:
Always be sure that the tool is
switched off and batteries are removed before
attempting to perform inspection or maintenance.
Failure to removing the batteries and switch off the
tool may result in accidental start up of the tool which
WARNING:
Always be sure that the blade is
sharp and clean for the best and safest perfor-
mance.
may cause kickback and result in a serious personal
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.

Adjusting the cutting angle

but rough handling may have affected the alignment. If
your tool is not aligned properly, perform the following:

Miter angle

Lower the handle fully and lock it in the lowered position
by the stopper pin. Push the carriage toward the guide
fence. Loosen the grip and the screws which secure the
pointer and miter angle scale.
Fig.70: 1. Screw on pointer 2. Screws on miter
angle scale 3. Miter scale
Probable cause (malfunction)
the tool.
into the tool.
the slot is dirty.
tool has not been pushed.
More than 10 tools are registered to the
vacuum cleaner.
registrations.
No power supply
from each other (out of the transmission
range).
Radio disturbance by other appliances
which generate high-intensity radio
waves.
Other users are using the wireless
activation of the vacuum cleaner with
their tools.
34 ENGLISH
Remedy
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
sure that the wireless activation lamp is blinking
in blue.
Set the stand-by switch on the vacuum cleaner to
Perform the tool registration again.
If more than 10 tools are registered to the vacuum
cleaner, the tool registered earliest will be cancelled
automatically.
Perform the tool registration again.
Supply the power to the tool and the vacuum
cleaner.
Get the tool and vacuum cleaner closer each other.
mately 10 m however it may vary according to the
circumstances.
Keep the tool and vacuum cleaner away from the
appliances such as Wi-Fi devices and microwave
ovens.
tools or cancel the tool registration of the other
tools.
Set the turn base to the 0° position using the positive
right and left) with the 0° position in the miter angle
scale and then tighten the screw on the pointer.
Fig.71: 1.
Bevel angle
0° bevel angle
Push the carriage toward the guide fence and lock the
sliding movement by the stopper pin. Lower the handle
fully and lock it in the lowered position by the stopper
bolt two or three revolutions counterclockwise to tilt the
blade to the right.
Fig.72: 1.
surface of the turn base using the triangular rule, try-
have set.
Fig.73: 1.
face of turn base
surface once again. Loosen the screw on the pointer.
scale and then tighten the screw.
-
2. Screw
2. Saw blade 3. -