Makita DLS110 Instruction Manual page 24

close to your desired positive stop angle while holding
move the turn base forward until the turn base is locked.
Adjusting the bevel angle
NOTICE:
Always remove the upper guide fences
and vertical vise before adjusting the bevel angle.
NOTICE:
When changing bevel angles, be sure
to position the kerf boards appropriately as
explained in the "Kerf boards" section.
NOTICE:
When tilting the saw blade, be sure to
raise the handle fully.
NOTICE:
Do not tighten the knob too hard. Doing
so may cause malfunction of the locking mecha-
nism of the bevel angle.
1.
Fig.21: 1. Knob
2. Pull and turn the latch lever to the position as
illustrated.
Fig.22: 1. Latch lever
3. Match the pointer with your desired angle on the
scale by moving the carriage then tighten the knob.
Fig.23: 1. Bevel angle scale 2. Pointer
slightly and then tilt it to the right while pressing down
the releasing button.
Fig.24: 1. Releasing button
If you perform a bevel cut greater than 45°, move the
carriage while sliding the releasing lever toward the
Fig.25: 1. Releasing lever
Set the latch lever in the position as illustrated and tilt
and tilt the carriage.
Fig.26: 1. Latch lever
CAUTION:
After changing the bevel angle,
always secure the knob.
Slide lock
carriage toward the guide fence until it stops. Pull the
stopper pin and rotate it 90°.
Fig.27: 1. Unlocked position 2. Locked position
3. Stopper pin
Switch action
WARNING:
into the tool, always check to see that the switch
trigger actuates properly and returns to the "OFF"
position when released. Do not pull the switch
trigger hard without pressing in the lock-off but-
ton. This can cause switch breakage. Operating a
tool with a switch that does not actuate properly can
WARNING:
operative switch trigger.
repaired before further usage or serious personal
WARNING:
by taping down or some other means.
a negated lock-off button may result in unintentional
WARNING:
you simply pull the switch trigger without press-
ing the lock-off button.
may result in unintentional operation and serious
for proper repairs BEFORE further usage.
Fig.28: 1. Switch trigger 2. Lock-off button 3. Hole
for padlock
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
padlock to lock the tool off.
WARNING:
cable any smaller than 6.35 mm (1/4") in diameter.
tool in the off position and unintentional operation
Electronic function
Constant speed control
which helps maintain a constant blade rotation speed
result in a very smooth cut.
Soft start feature
Laser beam action
For DLS111, DLS112 only
CAUTION:
Never look into the laser beam.
position (0) of the switch.
Fig.29: 1. Switch for laser
24 ENGLISH
Before installing the batteries
NEVER use tool without a fully
NEVER defeat the lock-off button
NEVER use the tool if it runs when
Do not use a lock with a shank or
-