Groove Cutting; Carrying Tool - Makita DLS110 Instruction Manual

Crown molding stopper
Optional accessory
Crown molding stoppers allow easier cuts of crown
molding without tilting the saw blade. Install them on the
At right 45° miter angle
Fig.52: 1. Crown molding stopper L 2. Crown mold-
ing stopper R 3.
At left 45° miter angle
Fig.53: 1. Crown molding stopper L 2. Crown mold-
ing stopper R 3.
molding stoppers. Refer to the table (C) for the miter angle.
Fig.54: 1. Guide fence 2. Crown molding stopper
(a) (b)
1. Inside corner 2. Outside corner
Table (C)
– Molding
position in
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Cutting aluminum extrusion
Fig.55: 1. Vise 2. Spacer block 3. Guide fence
4.
When securing aluminum extrusions, use spacer blocks or pieces
num. Use a cutting lubricant when cutting the aluminum extrusion
to prevent build-up of the aluminum material on the blade.
WARNING:
Never attempt to cut thick or
round aluminum extrusions.
may loosen during the cutting operation which may
4. Guide fence
4. Guide fence
(c) (d)
1 2
Miter angle Finished
piece
Right 45° Save the right
side of blade
Left 45° Save the left
side of blade
Save the right
side of blade
Right 45° Save the left
side of blade
5. Spacer block

Groove cutting

WARNING:
type of cut by using a wider type blade or dado
blade.
blade or dado blade could lead to unexpected cutting
results and kickback which may result in serious
WARNING:
to the original position when performing other
than groove cutting.
the stopper arm in the incorrect position could lead to
unexpected cutting results and kickback which may
For a dado type cut, perform as follows:
1.
described on previously.
2.
cut parallel grooves across the width of the workpiece
using a slide (push) cut.
Fig.56: 1. Cut grooves with blade
3. Remove the workpiece material between the
grooves with a chisel.

Carrying tool

Before carrying, make sure to remove the batteries and
check the following:
secured.
locked.
tion and secured.
Carry the tool by holding both sides of the tool base as
Fig.57
WARNING:
is for carrying and storage purposes only and not
for any cutting operations.
pin for cutting operations may cause unexpected
movement of the saw blade resulting in kickback and
CAUTION:
before carrying the tool. If portions of the tool move
-
or slide while being carried, loss of control or balance
-
30 ENGLISH
Do not attempt to perform this
Be sure to return the stopper arm
Stopper pin for carriage elevation
Always secure all moving portions
-
-