2.9 Tray/BNC Connector Assembly
When the BNC is prepared, feed it through the KT 74 mounting tray and attach the
washer combination in the following order:
Wave washer
Plain washer
Circlip washer.
The Circlip washer should be fitted with a set of Circlip pliers.
The two Molex connectors should be passed through the openings in the rear of the
tray, and then mounted firmly to the tray from the inside using the four M3 screws
supplied. Refer to Figure 2-11.
© Honeywell International Inc. Do not copy without express permission of Honeywell.
INSTALLATION MANUAL
89000007
Figure 2-10. BNC Completed Assembly
00239-
Page 2-18
15 Nov 2013