Honda CR-V 2017 Manual page 622

Jacking Points
Jack
Handle
Wheel Nut
Bar
Wrench as Jack Handle
2. Turn the end bracket clockwise as shown in
image until the top of the jack contacts the
jacking point.
u Make sure that the jacking point tab is
resting in the jack notch.
3. Raise the vehicle, using the jack handle bar
and the jack handle, until the tyre is off the
ground.
uuIf a Tyre Goes FlatuChanging a Flat Tyre
1How to Set Up the Jack
WARNING: The jack shall be placed on a flat and
stable surface on the same level as the vehicle is
parked.
Do not use the jack with people or luggage in the
vehicle.
Use the jack provided in your vehicle.Other jacks
may not support the weight ("load") or may not fit
the jacking point.
The following instructions must be followed to use
the jack safely:
•
Do not use while the engine is running.
•
Use only where the ground is firm and level.
•
Use only at the jacking points.
•
Do not get in the vehicle while using the jack.
•
Do not put anything on top of or underneath the
jack.
Continued
*
621