Casio GEC-10 User Manual page 79

Table of Contents

Advertisement

. Cleaning after Use
Perform the following steps to clean the product after using it under water or after it
becomes soiled with sand, dirt, or mud. Note that the [USB] cover must be closed
securely when performing these steps.
1.
Immerse the product in fresh water.
• Fill a bucket or other container with tap water or other fresh
water, and immerse the product for about 10 minutes.
Gently wipe dust, dirt, sand, and other matter from the
product with your fingers.
2.
Wipe off all moisture.
• Use a clean, dry, soft cloth to wipe the product dry. Moisture may remain on the
[USB] cover, even after you finish wiping it. With the [USB] cover open, leave
the product in the shade in a well-ventilated location to dry thoroughly. Closing
the [USB] cover while there are still water droplets present creates the risk of
corrosion and malfunction.
IMPORTANT!
• The temperature of the water used to wash the product should be no greater than
30°C (86°F). Never use detergent, hot water, or strongly running water to clean the
product. Doing so creates the risk of leaking and malfunction.
• Never swing the product around to remove water, and never use a dryer or other
intense heat to dry it.
• Never place the product in a washing machine to wash it.
. Precautions after Use
• Do not leave the product in a location subjected to very high or very low (below
freezing) temperatures. In particular, avoid leaving the product in areas exposed to
strong direct sunlight, in a motor vehicle on a hot day, etc. Doing so can cause loss
of splashproofing.
• Never use chemical agents for cleaning, rust proofing, moisture proofing, etc.
Doing so can cause loss of splashproofing.
• If the product becomes wet with seawater or river water, use the procedure under
"Cleaning after Use" to wash it off. Do not allow the product to remain wet for longer
than one hour. Failure to do so can cause deterioration of the exterior finish and
splashproofing properties.
• In order to maintain splashproofing, replacement of the product gaskets is
recommended once each year. Note that you will be charged for gasket
replacement. Contact a CASIO authorized service center or your original retailer
for gasket replacement.
79
Appendix

Advertisement

Table of Contents
loading

Table of Contents