Table of Contents
Advertisement
Inserting the MultiMediaCard (MMC)
The following figure illustrates how to insert the MMC card.
To insert the MMC, complete the following:
1.
Ensure the detector is deactivated.
2.
Remove the battery tray and set aside. Refer to
Replacing the
Batteries.
3.
Refer to the following figure; insert the MMC card
(label down; pins up) into the MMC card port.
Figure 5. Inserting the MultiMediaCard (MMC)
4.
Insert the battery tray back into the detector.
Replacing the Batteries
a Warning
To avoid personal injury, adhere to the following:
•
Replace the batteries as soon as the detector
emits a low battery alarm.
•
To prevent personal injury and/or damage to
equipment, use only batteries that are
recommended by BW Technologies. Refer to
Specifications
for a list of the approved
batteries.
•
Use only approved batteries that are properly
installed in the battery tray.
•
Charge the batteries using only a
recommended charger. Do not use any other
charger. Failure to observe this precaution can
lead to a fire or an explosion.
•
Do not change or charge batteries in a
hazardous location. Doing so will impair the
Intrinsic Safety of the unit and can cause a fire
or explosion.
GasAlertMicro
Maintenance
57
Advertisement
Table of Contents
Troubleshooting
