Honeywell BW GasAlertMicro User Manual page 14

GasAlertMicro
User Manual
⇒ Any rapid up-scaling reading that is followed by a declining or erratic reading can indicate a gas concentration
beyond upper scale limit. It may be hazardous!
⇒ Use only recommended AA alkaline or NiMH batteries that are properly charged and installed in the detector
case. Refer to Replacement Parts and
⇒ Charge NiMH batteries using the recommended charger only. Do not use any other charger. Failure to observe
this precaution can lead to fire or explosion.
⇒ Do not change or charge batteries in a hazardous location. Doing so will impair the Intrinsic Safety of the unit
and can lead to fire or explosion.
⇒ Read and observe all instructions and precautions that are provided with the charger. Failure to do so can
result in fire, electric shock, or other forms of personal injury and property damage.
⇒ Extended exposure of the GasAlertMicro to high concentrations of combustible gases and air may stress a
detector element, which can seriously affect its performance. If an alarm occurs due to high concentration of
combustible gases, recalibrate immediately. If required, replace the sensor.
⇒ Do not test the combustible sensor response with a butane cigarette lighter. This will damage the sensor.
⇒ Do not expose the detector to electrical shock or severe mechanical shock.
⇒ Do not attempt to disassemble, adjust, or service the detector unless instructions in the User Manual are
provided to perform a procedure, or if a part is listed as a replacement part. Use only
replacement parts.
⇒ Do not immerse the detector in liquids.
⇒ The detector Warranty will be voided if a customer, personnel, or third parties damage the detector during
repair attempts. Any Non-BW Technologies repair/service attempts will void this Warranty.
4
a
Cautions (cont.)
Accessories.
BW Technologies