Releasing the machine
–
To release the machine, squeeze the sides of the buckle (1) and take off the harness.
Be extremely careful to maintain control of the machine at this time. Do not allow the machine to be deflected toward you or anyone in the
work vicinity.
HOW TO START AND STOP ENGINE
Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refuelling. Place the unit on the ground taking care that the cutting tool does not come into contact
with the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION (2).
3) Choke lever
Close the choke lever.
Choke opening:
–
Full closing in cold or when the engine is cold.
–
Full or half opening if the engine is a bit warm, such as restarting engine
just after stopping during warm-up operation.
4) Primer pump
Continue to push the primer pump (3) until fuel comes into the primer pump.
(In general, 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
(1)
CLOSE
16
(2)
(1)
(3)