Table of Contents
Advertisement
Loosen the clamping screw on the bevel scale plate on
the front of the base. Set for the desired angle (0° - 45°)
by tilting accordingly, then tighten the clamping screw
securely.
Sighting
For straight cutting
Align the side edge of the base with your intended
cutting line on the workpiece.
► 1. Side edge of the base 2. Cutting line
For 45° bevel cutting
Align the inner edge of the guide notch in the base with
your intended cutting line on the workpiece.
► 1. Inner edge of the guide notch 2. Cutting line
Switch action
WARNING:
you simply pull the switch trigger without press-
ing the lock-off button. A switch in need of repair
may result in unintentional operation and serious
personal injury. Return tool to a Makita service center
for proper repairs BEFORE further usage.
WARNING:
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
CAUTION:
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
1
the "OFF" position when released.
CAUTION:
without pressing in the lock-off button. This can
cause switch breakage.
CAUTION:
diamond wheel rotation immediately after you
release the switch trigger. Hold the tool firmly to
2
respond the reaction of the brake when releasing
the switch trigger. Sudden reaction can drop the tool
off your hand and can cause a personal injury.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
1
► 1. Switch trigger 2. Lock-off button
2
9 ENGLISH
NEVER use the tool if it runs when
NEVER defeat the lock-off button
Before installing the battery car-
Do not pull the switch trigger hard
The tool starts to brake the
2
1
Advertisement
Table of Contents
