Table of Contents
Advertisement
45° bevel cutting
3.
Start feeding water to the diamond wheel by pull-
ing the water supply lever towards the "ON" (I) position.
Water flow can be adjusted by moving the water supply
lever. Turn the lever to the "ON" (I) position to increase
flow, and to the "OFF" (O) position to reduce flow.
1
2
3
► 1. Water supply lever 2. "ON" (I) position 3. "OFF"
(O) position
4.
Turn the tool on and wait until the diamond wheel
attains full speed. Then move the tool forward over
the workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed. Keep your
cutting line straight and your speed of advance uniform.
Having finished operation, be sure to set the lever
5.
in the "OFF" (O) position to cut flow off.
Wet cutting with water supply hose
CAUTION:
Always pay attention to the control
of water pressure. Too high water pressure may
cause water leak and splashing.
1.
Set the water supply lever in the "ON" (I) position.
1
2
3
► 1. Water supply lever 2. "ON" (I) position 3. "OFF"
(O) position
2.
Start feeding water to the diamond wheel by
turning the mains water supply on. Water flow can be
adjusted by moving the water supply lever. Turn the
lever to the "ON" (I) position to increase flow, and to the
"OFF" (O) position to reduce flow.
Hold the tool firmly. Set the base plate on the workpiece
3.
to be cut without the diamond wheel making any contact.
Straight cutting
15 ENGLISH
Advertisement
Table of Contents
