Table of Contents
Advertisement
The neck of the dust spout rotates freely. Position the
dust bag so that you can operate the tool comfortably.
When the dust bag is about one-third full, remove the
dust bag from the tool and pull the fastener out. Empty
the dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper collection.
1
► 1. Fastener
Connecting the vacuum cleaner
Optional accessory
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool.
► 1. Hose of the vacuum cleaner 2. Dust spout
1
2
14 ENGLISH
OPERATION
CAUTION:
THIS TOOL SHOULD ONLY BE
USED ON HORIZONTAL SURFACES.
CAUTION:
Be sure to move the tool forward
in a straight line and gently. Forcing and exerting
excessive pressure or allowing the wheel to bend,
pinch or twist in the cut can cause overheating of the
motor and dangerous kickback of the tool.
CAUTION:
Be sure to feed water to a wet-type
diamond wheel during wet cutting operations.
Wet cutting with water supply tank
Avoid filling the water supply tank
CAUTION:
with unclean water, such as muddy water, or else
the water outlet will be blocked resulting in dam-
age to the tool.
NOTICE:
Be sure to drain out water from the water
supply tank completely after each use.
Open the lid-cap of the water supply tank, and fill
1.
the tank with water. Then set the water-filled tank in the
water supply holder of the tool.
► 1. Lid-cap
Hold the tool firmly. Set the base plate on the
2.
workpiece to be cut without the diamond wheel making
any contact.
Straight cutting
1
Advertisement
Table of Contents
