Table of Contents
Advertisement
To remove the diamond wheel, press the shaft lock
fully so that the diamond wheel cannot revolve and use
the hex wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and diamond wheel.
2
1
► 1. Shaft lock 2. Hex wrench 3. Hex bolt 4. Loosen
5. Tighten
If the inner flange is removed, install it on
NOTICE:
the spindle with its wheel mounting part facing the
diamond wheel.
To install a diamond wheel, follow the removal pro-
cedure in reverse. Make sure the diamond wheel is
installed so that the arrows on the wheel point in the
same direction as the arrows on the wheel cover and
gear housing.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
6
1
2
4
5
► 1. Hex bolt 2. Outer flange 3. Diamond wheel
4. Inner flange 5. Cup washer 6. Arrow
5
4
3
6
3
Water supply tank
CAUTION:
careful not to spill water over the tool.
CAUTION:
on the wheel cover is set in the "OFF" (O) position
before installing the water supply tank.
Installing water supply tank
Insert the tank with the water supply cap pointing down-
wards into the water supply holder until it locks with a
click.
2
1
► 1. Water supply cap 2. Water supply holder
2
Removing water supply tank
Press the eject button to release the tank, and then pull
3
the tank off.
4
► 1. Eject button
11 ENGLISH
When filling the tank with water, be
Be sure that the water supply lever
1
1
Advertisement
Table of Contents
