Table of Contents
Advertisement
When adjusting the laser line appears on the left side of the saw blade
1
1. Screw to change the movable
range of the adjusting screw
3. Adjusting screw
5. Saw blade
When adjusting the laser line appears on the right side of the saw blade
1. Laser line
3. Screw to change the movable
range of the adjusting screw
For both adjustments, do as follows.
1.
Make sure that the tool is unplugged.
2.
Draw the cutting line on the workpiece and place it on the turn table. At
this time, do not secure the workpiece with a vise or similar securing
device.
3.
Lower the blade by lowering the handle and just check to see where the
cutting line and the position of the saw blade is. (Decide which position to
cut on the line of cut.)
4.
After decision the position to be cut, return the handle to the original
position. Secure the workpiece with the vertical vise without shifting the
workpiece from the pre-checked position.
5.
Plug the tool and turn on the laser switch.
6.
Adjust the position of laser line as follows.
The position of laser line can be changed as the movable range of the adjust-
ing screw for the laser is changed by turning two screws with a hex wrench.
(The movable range of laser line is factory adjusted within 1 mm from the side
surface of blade.)
To shift the laser line movable range further away from the side surface of
blade, turn the two screws counterclockwise after loosening the adjusting
screw. Turn these two screws clockwise to shift it closer to the side surface of
the blade after loosening the adjusting screw.
Refer to the section titled "Laser line action" and adjust the adjusting screw so
that the cutting line on your workpiece is aligned with the laser line.
3
5
4
2
2. Hex wrench
4. Laser line
1
2
3
2. Saw blade
006991
006990
27
Advertisement
Table of Contents
