Table of Contents
Advertisement
1. Vise
2. Spacer block
3. Guide fence
4. Aluminum extrusion
5. Spacer block
22
5.
Compound cutting
Compound cutting is the process in which a bevel angle is made at the
same time in which a miter angle is being cut on a workpiece. Compound
cutting can be performed at angle shown in the table.
Miter angle
Left and Right 45˚
Right 50˚
Right 57˚
When performing compound cutting, refer to "Press cutting", "Slide cut-
ting", "Miter cutting" and "Bevel cut" explanations.
6.
Cutting aluminum extrusion
001844
When securing aluminum extrusions, use spacer blocks or pieces of
scrap as shown in the figure to prevent deformation of the aluminum. Use
1
a cutting lubricant when cutting the aluminum extrusion to prevent build-
up of the aluminum material on the blade.
2
CAUTION:
3
•
Never attempt to cut thick or round aluminum extrusions. Thick aluminum
4
extrusions may come loose during operation and round aluminum
5
extrusions cannot be secured firmly with this tool.
7.
Wood facing
Use of wood facing helps to assure splinter-free cuts in workpieces.
Attach a wood facing to the guide fence using the holes in the guide
fence.
See the figure concerning the dimensions for a suggested wood facing.
Thickness of wood facing when cutting 60 mm high workpiece
Left and Right 45˚
15mm or Over
1. Hole
CAUTION:
•
Use straight wood of even thickness as the wood facing.
•
Use screws to attach the wood facing to the guide fence. The screws
should be installed so that the screw heads are below the surface of the
wood facing.
•
When the wood facing is attached, do not turn the turn base with the
handle lowered. The blade and/or the wood facing will be damaged.
Left and Right 45˚
Left 40˚ and Right 45˚
Left 25˚ and Right 45˚
Miter angle
Thickness of wood facing
0˚
410mm or Over
85mm
70mm
1
006999
Bevel angle
006998
Over 20 mm
Over 15 mm
92mm 105mm
1
2
2. Center of wood facing
006982
Advertisement
Table of Contents
