Table of Contents
Advertisement
1
1. Right 45° bevel angle adjusting
bolt
2. Left 45° bevel angle adjusting bolt
1
3
1. Workpiece
2. Cutting line
3. Holder assembly
(optional accessory)
1
2
1. Vertical vise
2. Holder assembly
(optional accessory)
26
(2)
006986
2
006987
Adjusting the position of laser line
006988
WARNING:
•
As the tool is plugged when adjusting the position of laser line, take a full
caution especially at switch action. Pulling the switch trigger accidentally
cause an accidental start of the tool and personal injury.
CAUTION:
2
•
Never look into the laser beam directly. Direct laser beam causes
damage to your eyes.
•
Never apply a blow or impact to the tool. A blow or impact causes the
incorrect position of laser line, damage to the laser beam emitting part or
a short life of the tool.
006989
45° bevel angle
Adjust the 45° bevel angle only after performing 0° bevel angle
adjustment. To adjust left 45° bevel angle, loosen the lever and tilt
the blade to the left 45° bevel angle. Turn clockwise the left 45°
bevel angle adjusting bolt on the right side of the arm holder two or
three revolutions. Carefully set the side of blade with the top sur-
face of turn table at 45° bevel angle using the triangular rule by
turning the left 45° bevel angle adjusting bolt.
Adjust right 45° bevel angle this way.
Advertisement
Table of Contents
