Table of Contents
Advertisement
1
2
1. Arm
2. 0° bevel angle adjusting bolt
3. Lever
1
1. Triangular rule
2. Saw blade
3. Top surface of turn base
1
2
1. Pointer
2. Screw
2.
Bevel angle
(1)
006984
3
001819
2
3
006985
0° bevel angle
Push the carriage toward the guide fence and tighten two clamp
screws to secure the carriage. Lower the handle fully and lock it in
the lowered position by pushing in the stopper pin. Loosen the
lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower bolt) on the arm holder
two or three revolutions counterclockwise to tilt the blade to the
right.
Carefully square the side of the blade with the top surface of the
turn base using the triangular rule, try-square, etc. by turning the
0° bevel angle adjusting bolt clockwise. Then tighten the lever
securely.
Make sure that the pointer on the arm point to 0° on the bevel scale
on the arm holder. If it does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so that it will point to 0°.
25
Advertisement
Table of Contents
