Table of Contents
Advertisement
1
1. Adjusting screw
1. Clamping screw
2. Lever
1. Clamping screw
(2)
006963
3.
After setting the range, always tighten the lever securely.
Fine adjusting for left bevel angle
006964
1.
Loosen the lever. At this time, make sure that the clamping screw is loos-
ened. If not, loosen it.
2
1
2.
Push the handle to the left to tilt the saw blade until the pointer roughly
006965
points to an angle near the desired angle on the bevel scale. Then
tighten the clamping screw clockwise.
1
When the green part in the window on the scale label is located on
the right side,
Turn the fine-adjusting screw counterclockwise and the green part
moves to the left. Turn it until the entire part of the window display
becomes green.
11
Advertisement
Table of Contents
