Makita UM164D Instruction Manual page 15

For cordless hedge trimmer use
This tool can be used as a hedge trimmer by using the
hedge shear blade (optional accessory) and 2-way
change set (optional accessory).
To use this tool as a hedge trimmer, replacing the grass
shear blades with the hedge shear blades is required.
For removing the grass shear blades, refer to the
aforementioned section titled "Installing or removing
1. Hedge shear blade
2. Hedge shear blade cover
3. Storage case
011044
Chip receiver for hedge trimming (for Hedge
•
Trimmer)
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
Installing or removing hedge shear blades
CAUTION:
Before installing or removing shear blades, always
•
be sure that the tool is switched off and the battery
cartridge is removed.
When replacing the shear blades, always wear
•
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
1
grass shear blades". For installing the hedge shear
blades, refer to the section below titled "Installing or
removing hedge shear blades".
Hedge shear blade assembly (for Hedge Trimmer)
•
2-way change set consisting of the following two
•
accessories
Hedge shear blade cover (for Hedge Trimmer)
•
Storage case (for blade bottom section)
•
2
Installing the hedge shear blades
1
1. Crank
2. Undercover
3. Shear blades
010904
Prepare the crank, the undercover and new shear
blades.
1
1. Basic alignment line on the tool housing
2. Pins
010905
15
3
2
3
2