Table of Contents
Advertisement
Problem
The oven does not heat up.
The lamp does not operate.
The display does not show
the time during the off sta-
tus.
The core temperature sensor
does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows an error
code that is not in this table.
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
Possible cause
The fuse is blown.
The lamp is defective.
The display is deactivated.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
You want to start the Defrost
function, but you did not re-
move the core temperature
sensor plug from the socket.
There is an electrical fault.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Touch
and
at the
same time to activate the
display again.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Remove the core tempera-
ture sensor plug from the
socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
47
Advertisement
Table of Contents
