Table of Contents
Advertisement
10
www.aeg.com
4.3 Heat up indicator
If you activate an oven function, the bars
come on in the display. The bars
show that the temperature in the
appliance increases or decreases.
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the appliance.
Refer to "Care and
cleaning" chapter.
Clean the appliance and the accessories
before first use.
Put the accessories and the removable
shelf supports back to their initial
position.
5.2 Setting the time
After the first connection to the mains, all
symbols in the display are on for some
seconds. For the subsequent few
seconds the display shows the software
version.
After the software version goes off, the
display shows h and 12:00. "12" flashes.
1. Touch
Water hardness
Class
1
2
3
4
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
or
to set the hours.
Calcium deposit
(mmol/l)
dH
0 - 7
0 - 1.3
7 - 14
1.3 - 2.5
14 - 21
2.5 - 3.8
over 21
over 3.8
When the appliance is at the set
temperature, the bars go off the display.
2. Touch
or
3. Touch
or
4. Touch
or
The Temperature / Time display shows
the new time.
5.3 Changing the time
You can change the time of day only
when the appliance is on.
Touch
again and again until
flashes in the display.
To set the new time of day, refer to
"Setting the time".
5.4 Setting the hardness level
for the water
When you connect the appliance to the
mains, you have to set the water
hardness level.
The table below explains the water
hardness range with the corresponding
Calcium deposit (mmol/l) and the quality
of the water.
Calcium deposit
(mg/l)
0 - 50
50 - 100
100 - 150
over 150
1. Take the four colour change strip
supplied with the steam set in the
oven.
.
to set the minutes.
.
Water classi-
fication
Soft
Moderately
hard
Hard
Very hard
Advertisement
Table of Contents
