Makita DLS211 Instruction Manual page 39

5.
Install the batteries and turn on the laser switch.
6.
Loosen the adjusting screw. To move the laser line
away from the blade, turn the range adjustment screws
counterclockwise. To move the laser line close to the
blade, turn the range adjustment screw clockwise.
Adjusting the laser line on the left side of the blade
► Fig.85: 1. Adjusting screw 2. Range adjustment
screw 3. Hex wrench 4. Laser line 5. Saw
blade
Adjusting the laser line on the right side of the
blade
► Fig.86: 1. Adjusting screw 2. Range adjustment
screw 3. Hex wrench 4. Laser line 5. Saw
blade
7. Slide the adjusting screw to the position that the
laser line comes onto the cutting line and then tighten it.
NOTE: The movable range of laser line is factory
adjusted within 1 mm (0.04") from the side surface of
saw blade.
Cleaning the laser light lens
The laser light becomes hard to see as the lens for
the laser light gets dirty. Clean the lens for laser light
periodically.
► Fig.87: 1. Screw 2. Lens
Remove the batteries. Loosen the screw and pull out
the lens. Clean the lens gently with a damp soft cloth.
Do not remove the screw which
NOTICE:
secures the lens. If the lens does not come out,
loosen the screw further.
Do not use solvents or any petro-
NOTICE:
leum-based cleaners on the lens.
After use
After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
OPTIONAL
ACCESSORIES
These Makita accessories or
WARNING:
attachments are recommended for use with your
Makita tool specified in this manual. The use of
any other accessories or attachments may result in
serious personal injury.
Only use the Makita accessory
WARNING:
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
personal injury.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Steel & Carbide-tipped saw blades
• Vertical vise
• Horizontal vise
• Crown molding stopper set
• Dust bag
• Triangular rule
• Hex wrench
• Hex wrench (for laser adjustment)
• Wireless unit (for DLS211)
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
39 ENGLISH