Specifications - Makita LH1201FL Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model
Blade diameter
Blade body thickness
Hole diameter
Max. Cutting capacities at 90°in the table saw (bench saw mode)
-1
No load speed (min )
Laser Type
Table size (W x L)
Dimensions (L x W x H)
Net weight
Safety class
Max. Cutting capacities (H x W) with blade 305 mm in diameter in the miter saw mode
• Due to our continuing program of research and development, the specifications herein are subject to change with-
out notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When using the tool in the miter saw mode,
secure the top table at the topmost position
so that the saw blade never protrudes from
the top surface of the top table.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
For all countries other than
European countries
For European countries
Bevel angle
90°
45°
Red Laser 650 nm, < 1mW (Laser Class 2)
610 mm x 535 mm x 692 mm
90°
95 mm x 155 mm
62 mm x 200 mm
64 mm x 155 mm
40 mm x 200 mm
Never look into the laser beam. Direct laser
beam may injure your eyes.
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.
Intended use
The tool is intended for accurate straight cutting and
(only when used as a miter saw on the lower table)
miter cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
9 ENGLISH
LH1201FL
305 mm
1.9 mm or less
25.4 mm
30 mm
52 mm
3,800
307 mm x 465 mm
20.9 kg
/II
Miter angle
45° (left to right)
95 mm x 110 mm
62 mm x 135 mm
64 mm x 65 mm
40 mm x 85 mm