D-Link AirPremier DWL-2210AP Manual page 53

Setting the Ethernet (Wired) Interface
Field
Guest Access
Using VLANs for the Guest Network
If you enable Guest Access, two virtual LANs (VLANs) will be used: one for the Internal
network and one for the Guest network. To use VLANs, the LAN port on the access
point must be connected to a tagged port on a
define two different Virtual LANs on this Administration page. (For more information,
see "Setting up Guest Access" in this manual.)
Enabling Guest Access will enable the "VLAN" settings where you must provide a VLAN
ID. See also "Configuring Guest Interface Ethernet Settings" in this manual.
Field Description
Then, reconnect via the Administration Web pages to the new IP address.
(If necessary, check with the infrastructure support administrator regarding
the VLAN and DHCP configurations.)
Description
By default, the D-Link DWL-2210AP ships with Guest
Access disabled.
• To enable Guest Access, click Enabled.
• To disable Guest Access, click Disabled.
If you enable Guest access and configure the Guest and Internal
interfaces to use VLANs, you may lose connectivity to the access point.
First, be sure to verify that the switch and
can support VLANs per the
the VLAN on the Advanced > Ethernet page, physically reconnect
the Ethernet cable on the switch to the tagged packet (VLAN) port.
VLAN capable switch and then you must
DHCP
IEEE 802.1Q standard. After configuring
53
server you are using