D-Link AirPremier DWL-2210AP Manual page 30

Configuring Basic Settings
Review / Describe the Access Point
Field
Field Description
IP Address
MAC Address
Firmware Version
Location
Description
Shows IP address assigned to this access point. This field is
not editable because the IP address is already assigned (either
via DHCP, or statically through the Ethernet (wired) settings as
described in "Configuring Guest Interface Ethernet Settings" in
this manual.
Shows the MAC address of the access point.
A MAC address is a permanent, unique hardware address for
any device that represents an interface to the network. The MAC
address is assigned by the manufacturer. You cannot change
the MAC address. It is provided here for informational purposes
as a unique identifier for an interface.
The address shown here is the MAC address for the bridge (br0).
This is the address by which the AP is known externally to other
networks.
To see MAC addresses for Guest and Internal interfaces on the
AP, see the Status > Interfaces tab.
Version information about the firmware currently installed on the
access point.
As new versions of the D-Link DWL-2210AP firmware become
available, you can upgrade the firmware on your access points
to take advantages of new features and enhancements. (You
can download the most recent firmware from
http://support.dlink.com/).
For instructions on how to upgrade the firmware, see
"Upgrading the Firmware" in this manual.
Specify a location description for this access point.
30 30