D-Link AirPremier DWL-2210AP Manual page 22

Quick Steps for Setup
Step 3. Run KickStart Wizard on the CD-ROM to find access
points on a DHCP network
The DWL-2210AP is DHCP enabled by default. The DWL-2210AP
CD-ROM contains the KickStart Wizard to simplify access point configuration
on a network with a DHCP server. Use Kickstart only when there is a DHCP
server in your network.
KickStart Wizard is an easy-to-use utility for discovering and identifying new D-Link
DWL-2210APs in a network with a DCHP server. KickStart scans the network looking
for access points, and displays ID details on those it finds.
• Keep in mind that KickStart Wizard recognizes and configures only D-Link
DWL-2210APs. Kickstart will not find any other devices.
• Run Kickstart only in the subnet of the "Internal" network (
the guest subnetwork.
• Kickstart Wizard will find only those access points that have IP addresses. IP addresses
are dynamically assigned to APs if you have a
in mind that if you deploy the AP on a network with no DHCP server, the default static IP
address (192.168.0.50) will be used.
Use caution with non-DHCP enabled networks: Do not deploy more than one new AP on
a non-DHCP network because they will use the same default static IP addresses and
conflict with each other. (For more information, see "Understanding Dynamic and Static IP
Addressing on the D-Link DWL-2210AP" and "How Does the Access Point Obtain an IP
Address at Startup?" )
Run the CD-ROM on a laptop or computer that is connected to the same network as
your access points and use it to step through the discovery process as follows:
1. Insert the CD-ROM
into the CD-ROM drive on
your computer, and click
Kickstart.
The Kickstart Welcome
screen will appear (as
shown on the next page).
DHCP server running on the network. Keep
22 22
SSID
). Do not run Kickstart on