Table of Contents
Advertisement
INITIAL SETUP
QUICK SETUP
SETTING THE TIME AND DATE
(cont.)
6.
PM
7.
Use the keypad to enter the month (01-12)
and day (01-31). To edit your entry, press
the soft key under "
" to re-enter the
date.
8.
PM
9.
VERIFYING STATION AND LINE CONFIGURATION
1.
Press
. The LINE 1 INDICATOR will light green and the speakerphone LED will
LINE 1
light red.
2.
The station ID will appear in the display to indicate the station is in use.
3.
Dial the telephone number for line 2 on a standard phone. The LINE INDICATOR for line 2
should flash red. If the line indicator, for the line you called, does not flash, check to make
sure lines are correctly installed.
4.
Repeat step 2 and call the telephone numbers for line 3 and 4.
5.
If the indicators of the lines you called flashed, you have successfully installed this station!
VERIFYING SYSTEM CONFIGURATION
To verify that all stations are communicating,
1.
Press and hold
.
PAGE ALL
2.
"
" and the station icons for all properly connected stations will appear in the Station
Status Display. It may take a moment for all the icons to appear.
3.
Check to see if all stations connected to line 1, appear in the display. If they did, the system is
successfully configured. If all the stations do not appear in the display, note the station(s) that
did not appear in the display. Go to the noted station and make sure the lines are connected
and in the correct line jacks.
(cont.)
10.
Press the soft key under "
the correct week day appears in the
display.
11.
12.
"
appear in the display.
AM
12
INSTALLATION CHECKLIST
AC adapter is connected at stations
Line cords have been connected
Line 1 is common on all stations
All stations have been assigned an extension number
" until
The time and date have been set at all stations
Once initial setup is complete, the SI-460 is ready to use with the following program defaults.
Programming each of the settings below needs to be done at each station:
PROGRAM FEATURE
" will
Always Ring
Answering System
Answering System Ringer The answering system ringer is set to 4 rings
Area Code
Auto Answer
Auto Attendant
Caller ID
Call Screen
Call Waiting Caller ID
Default Ringer Volume
Flash
Greeting Mode Select
Greeting Select
Greeting Timer
Outside Line
Pre-Recorded Greeting
Private Line
Remote Code
Ringer
INITIAL SETUP
QUICK SETUP
(cont.)
SYSTEM DEFAULTS
FACTORY PRESET SETTING
Always Ring is OFF
The answering system is OFF
The area code is set to "000"
Auto Answer is ON for intercom use
Auto Attendant is OFF
Caller ID is set to ON and ANSWER,
so all answered caller ID records are retained
Call Screen is set to OFF
Call Waiting Caller ID is ON
The default ringer volume is set to HIGH
(on the back of the SI-460)
Flash is set to 600 MS
The greeting mode is set to ANSWER
The greeting select mode is set to answer
with greeting 1
Greeting Timer is OFF
The outside line is set to "-"
When the user has not recorded a greeting,
when they play the greeting they will hear
" Please record a new greeting one. "
Private Line is OFF on line 3 and 4
The remote code is set to "1-2-3"
The ringer is ON for all installed lines
13
REFERENCE PAGE
18
22
25
16
15
34
30
47
30
17
17
24
22
23
16
20
18
31
17
Advertisement
Chapters
Table of Contents
