Additional Information; Wall Mounting Pedestal; Desk Top Pedestal; Power Failure Operation - Casio SI-460 User Manual

ADDITIONAL INFORMATION

WALL MOUNTING PEDESTAL

The SI-460 can easily be wall mounted by following these instructions.
1.
Install two screws into the wall using the template, on this page, as
a guide.
NOTE:
Purchase wood screws, round head, brass, size #10, 1 ¼ inch in length.
2.
Remove the mounting pedestal from the desk mount position.
3.
Thread the AC adapter cord and line cords through channels on the
bottom of the SI-460.
4.
Snap the pedestal bracket, with the narrow end of the wedge
pointing upward, into the bottom four wall mount ports and push
up to lock in place.
5.
Attach the telephone to the wall.

DESK TOP PEDESTAL

1.
Remove the mounting pedestal from the
desk mount position.
2.
Thread the AC adapter cord and line cords
through channels on the bottom of the
SI-460.
3.
Snap the pedestal bracket, with the narrow
end of the wedge pointing downward, into
the top four wall mount ports and push up
to lock in place.
4.
Place the telephone on the desk.
56
ADDITIONAL INFORMATION

POWER FAILURE OPERATION

Function Power Failure with Batteries
Line 1 (only) Operates
Line Status Indication Operates
Handset Use Operates
Flash Operates
The SI-460 does not require a battery during a power failure to maintain greetings, recorded
messages, programmed information and caller ID records. During a power failure without the
battery, the time and day will be erased after an hour.
For basic telephone operation on line 1 during power failure, install four AA Alkaline batteries.
The battery icon on the display will become solid when new batteries are installated.

PERMANENT MEMORY PROTECTION

Programmed information such as caller ID records, autodial entries and station ID are all stored
on the SI-460's memory indefinitely, or until you choose to completely reset the system.

SHORT TERM MEMORY

In a power failure, the time and date setting will be maintained for up to 1 hour, if batteries are
installed. See below for "BATTERY INSTALLATION."

BATTERY INSTALLATION

Install four AA alkaline batteries (not included) into the bottom side of the SI-460 base to enable
the telephone to operate up to 1 hours during a power failure. Batteries are not necessary for the
SI-460 to operate and retain stored data with AC power.
1.
Turn the SI-460 over and remove the mounting pedestal if attached.
2.
Remove the battery cover.
3.
Install four AA alkaline batteries. Make sure the ribbon lies under the batteries and the
batteries are in the correct directions.
4.
Replace the cover.
Power Failure without Batteries
Will not operate
Will not operate
Will not operate
Will not operate
57