Table of Contents
Advertisement
INITIAL SETUP
CREATING YOUR UNIQUE SYSTEM
PLANNING YOUR SYSTEM
1. Identify the number of stations you will need. (Maximum is twelve)
2. Determine how many lines are needed. (Maximum is four per station)
3. Identify how many lines you want connected to each Executive Series phone in the system.
4. Determine which stations will get which lines.
5. Decide if each station requires a private line.
Create a chart to assist you in organizing your phone system, for example:
Line 1:
Line 2:
111-4567
222-4567
Station 11
X
X
Station 12
X
X
INSTALLATION CHART
Station
Line 1:
Line 2:
Line 3:
-
-
-
11
12
13
14
15
16
17
18
19
20
21
22
(cont.)
Line 3:
Line 4:
Location / User
333-4567
444-4567
X
X
Receptionist Area / Lisa
X
Warehouse / Jake
Line 4:
Location / User
-
8
INSTALL YOUR SI-460 SYSTEM
PHONE INSTALLATION
Any equipment connected to the phone line such as faxes, other phones or modems should be
temporarily disconnected. Follow the installation sequence for best results.
Connecting Lines 1 and 2
1. CONNECT one end of the telephone cord into the jack labeled L1/L2, on the bottom of the
SI-460.
2. Guide the line cord through one of the cord channels on the bottom of the unit.
3. Connect the other end of the telephone cord into the two-line RJ14 wall jack.
Connecting Lines 3 and 4
4. CONNECT one end of the other telephone cord into the jack labeled L3/L4, on the bottom of
the SI-460.
5. Guide the line cord through the cord channels on the bottom of the unit.
6. CONNECT the other end of the telephone cord into the two-line RJ14 wall jack.
7. Connect the AC adapter plug into the AC adapter outlet on the bottom of the SI-460.
8. Thread the AC adapter cord through the channel on the bottom of the unit to prevent
accidental disconnection.
9. Determine if you want the phone to set on your desk or to be wall mounted. Install the
pedestal. See PEDESTAL INSTALLATION on page 56.
10. Plug one end of the coiled handset cord into the handset. Plug the other side of the coiled
cord into the outlet on the left side of the SI-460 base with the icon of a handset below. Place
the handset in the cradle.
11. Plug the AC adapter into an electrical wall outlet. The LCD will flash and you will see
"
". "
screen if the soft key under START is not pressed within 15 seconds. The SI-460 is now
ready to program. See page 11.
12. Install four AA alkaline batteries (not included) into the bottom side of the SI-460 base to
enable the telephone to operate up to 1 hour during a power failure. (See page 57 for battery
installation). Batteries are not necessary for the SI-460 to operate and retain stored data with
AC power.
" will scroll across the
9
Advertisement
Chapters
Table of Contents
