Performing A System Update; Station Reset; Displays - Casio SI-460 User Manual

ADDITIONAL INFORMATION

PERFORMING A SYSTEM UPDATE

When a system update is performed, it updates the status of all the stations in the system.
A system update should be performed when one of the following occurs:
Line 1 has been disconnected and then reconnected (done automatically when
reconnected)
When removing a station to the system
When a unit changes it's station ID
To perform a system update:
1.
Press .
PROGRAM
2.
3.
4.

STATION RESET

If line conditions cause communication errors between station, units may need to be reset as a
remedy. A reset will not erase any stored data.
To reset a station,
1.
Take the tip of a pen and insert it into the small opening on the back of the unit labeled
"RESET."
2.
You will hear a click and the display and station LEDs will briefly turn off and then back on.
The unit will reconfirm the station's ID, clear the date, and perform a system update.
5.
" " will appear in the
display.
6.
When the update has completed,
" " will appear in the display.
7.
Press to exit.
PROGRAM
58
ADDITIONAL INFORMATION

DISPLAYS

DISPLAYED MESSAGE
Tried to access a line when all
lines were in use.
The auto attendant has already
been established at another
station.
VOICEMAIL
ON/OFF
auto attendant station.
This caller blocked their caller
ID record.
Station has joined a
conference call.
Station is transferring a call.
was pressed and
CALLER ID
there are no records.
Greeting timer is on.
Station is recording a
conversation.
The displays prompts you to
enter the station number of
the unit you want to transfer a
call to or intercom.
STATUS ACTION
Try a little later.
Only one auto attendant
station can be active. See page
32 under "AUTO ATTENDANT
AND DIRECTED
MESSAGING."
Voice mail cannot be turned
was pressed on the
off at the auto attendant
station when auto attendant is
on, auto attendant is already
on at another station or when
trying to program the auto
attendant station to a caller ID
setting other than "ANSWER."
See "CALL WAITING CALLER
SERVICE OPTIONS" on page
29.
See page 46.
See page 44.
You may not subscribe to
caller ID. See "PROGRAM-
MING CALL WAITING CALLER
ID" section on pages 29-30.
To program a primary greeting
other than greeting 1 or 2,
turn greeting timer off. Then
select the primary greeting
you want to play. See page 22
under "SELECTING THE
PRIMARY GREETING."
RECORD
Press to end.
MEMO/CONV
Use the keypad to enter two-
digit ID of the station you
want to transfer a call to or
intercom.
59