Signal Input Settings (Input Menu); Making Phase Adjustment And Through Mode Settings - Sony MVS-8000 User Manual

Signal Input Settings (Input Menu)

For setup relating to signal inputs, use the Switcher >Input menu.
To display the Input menu
In the Engineering Setup menu, select VF3 'Switcher' and HF2 'Input.'
The status area shows source numbers and source names, input signal phase,
and through mode on/off setting.
For inputs 1 to 8 (or 1 to 16 when two MKS-8450G format converter boards
are installed), there is an indication (Enable/Disable) of whether or not to use
the format converter. When two MKS-8450G boards are installed, there is also
an indication of whether or not to use the Frame Delay function (see page 26).
The following functions are available here.
• Input Phase Adjust: Carry out phase adjustment for each primary input.
• Through Mode: Set through mode for the input side. This applies only to
the primary inputs, and can be set independently for each primary input.
• Video Process: Switch video processing on or off for each input signal, and
adjust the brightness, hue and so forth.
• Matte Illeg. Color Limit: Switch the illegal limiter on or off for the signal
generated by the switcher internal matte generator.
• FC Adjust (for MVS-8000G only): Select the conversion (up-conversion,
cross-conversion, or down-conversion) when the format converter is applied
to an input.

Making Phase Adjustment and Through Mode Settings

1
2
3
142
Signal Input Settings (Input Menu)
In the Switcher >Input menu, select the input signal to which the settings
apply.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1 Src No Input signal selection
The selected input signal appears in reverse video.
Press [Input Phase Adj].
To adjust the phase, adjust the following parameter.
Setting values
1 to 80