Sony MVS-8000 User Manual page 269

Icon Title
Format
GPI Input
GPI
Output
268
Error Messages
Message
No external HDD was found
(–2).
Format operation failed (–10).
Format operation failed (–11).
Cannot access the partition
(–12).
Cannot access the directory
(–20).
Cannot access the directory
(–21).
The external HDD is busy
(–22).
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Description
2561: Frame Memory >External HDD >Format
In the above menu, an attempt was made to
execute [Format] but the external hard disk
could not be recognized. Check that the
external hard disk is correctly connected.
2561: Frame Memory >External HDD >Format
In the above menu, an attempt was made to
execute [Format] but formatting the external
hard disk was not completed correctly.
2561: Frame Memory >External HDD >Format
In the above menu, an attempt was made to
execute [Format] but the logical drives of the
external hard disk could not be accessed.
Check that the external hard disk is correctly
formatted.
2561: Frame Memory >External HDD >Format
In the above menu, an attempt was made to
execute [Format] but the directory of the
external hard disk could not be accessed.
2561: Frame Memory >External HDD >Format
In the above menu, an attempt was made to
execute [Format] of the external hard disk
which was busy and could not be accessed. Try
again after you check that the access lamp of
the hard disk or the indicator of the menu is
turned off.
7325.1/2: Engineering Setup >Panel >Device
Interface >GPI Input
7344.1/2: Engineering Setup >DME >Device
Interface >DME1 GPI Input
7344.5/6: Engineering Setup >DME >Device
Interface >DME2 GPI Input
7352/7352.1: Engineering Setup >DCU >GPI
Input Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
7325.3/4: Engineering Setup >Panel >Device
Interface >GPI Output
7337.2/3: Engineering Setup >Switcher
>Device Interface >GPI Output
7337.4/5: Engineering Setup >Switcher
>Device Interface >GPI Output
7344.3/4: Engineering Setup >DME >Device
Interface >DME1 GPI Output
7344.7/8: Engineering Setup >DME >Device
Interface >DME2 GPI Output
7354/7354.1: Engineering Setup >DCU >GPI
Output Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.