Setting The Monitor Output - Sony MVS-8000 User Manual

Setting the Monitor Output

To set the signals output from the four monitor output connectors, use the
following procedure.
Notes
This setting is valid when an SDI-interfaced MVE-8000A or an MVE-9000 is
used.
1
2
3
4
5
190
Settings Relating to Signal Outputs (Output Menu)
In the DME >Output menu, press [Monitor Output].
The Monitor Output menu appears.
In the <Select> group, select the DME to which the setting applies.
DME1: Select DME1.
DME2: Select DME2.
In the list on the left of the status area, press directly on the monitor output
for which you want to make setting.
In the list on the right of the status area, press directly on the signal you
want to output.
Press [Set].
The selection is reflected in the monitor output.