off and the power may go off before the action is completed. This may
corrupt the setup settings. It is therefore recommended to use Level Enable
to avoid such a situation.
• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising
edge the set AUX bus primary input is used. On a falling edge, the original
state of the cross-point is restored. If the GPI trigger is applied repeatedly at
short intervals (0.5 second or less), the cross-point switching may not be
carried out correctly. In this case, apply the GPI trigger again.
• If "SWR Format" or "System Format" is selected for "Action" when the
format converter is used on the MVS-8000G, you can set the conversion
formats of the format converter for "FC Input 1-8" and "FC Input 9-16."
In place of the conversion format, you can also select "Frame Delay," but in
this case "FC Input1-8" is disabled.
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
2
3
202
GPI Input Setting (GPI Input Assign Menu)
In the DCU >GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
Parameter
1
No
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Adjustment
Signal format/screen aspect ratio
selection
Setting values
1 and upwards