Honda E Manual page 642

Air Valve
a
Switch
b
OFF
c
ON
d
10. Turn on the air compressor and inflate the
tyre to the specified air pressure.
u The compressor starts injecting sealant
and air into the tyre.
u Refer to the driver's doorjamb label for
the specified pressure.
11. After the air pressure reaches to specified
pressure, turn off the compressor.
u Check the air pressure gauge on the air
compressor.
u If overinflated, release the air by turning
the air valve. Be careful not to spill any
sealant.
12. Unplug the plug from the accessory power
socket.
13. Unscrew the air compressor hose from the
tyre valve. Install the hose cap.
u Be careful not to spill any sealant when
the hose is disconnected. Wipe away
any spills.
uuIf a Tyre Goes FlatuTemporarily Repairing a Flat Tyre
1Injecting Sealant and Air
Inform the use of tyre sealant when you ask a Honda
dealer or the road assistant service for replacing or
repairing the flat tyre.
This air compressor is designed for the automotive
tyre. Check the following:
•
The power supply of the air compressor is limited to
your vehicle's 12-volt DC accessory power socket.
•
Do not operate the temporary tyre repair kit
compressor for more than 15 minutes. The
compressor can overheat and become permanently
damaged.
Make it cool down when using the compressor
continuously.
Continued 641