Standby Settings; Standby Control; Standby Delay; Standby Wakeuponmotiondetection - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Standby settings

Standby Control

Define whether the device should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: The device will not enter standby mode.
On: The device will enter standby mode when the Standby Delay has timed out.

Standby Delay

Define how long (in minutes) the device shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).

Standby WakeupOnMotionDetection

Automatic wake up on motion detection is a feature that allows the device to detect when
people enter the room. The feature is based on ultrasound detection.
Ultrasound signals for motion detection are not emitted when both this setting AND the
RoomAnalytics PeoplePresenceDetector setting are switched Off. The Audio Ultrasound
MaxVolume and Proximity Mode settings has no effect on motion detection.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: Wake up on motion detection is disabled.
On: When people walk into the room the device will automatically wake up from standby
(only applicable to DX80).
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
140
Administrator Guide
Device settings Device settings Appendices