Cisco DX80 Quick Reference Manual

This unit is available as a desktop, mobile cart or fixed unit.
Touchscreen-
this unit does
not require a
remote control.
Loudspeaker
Microphone
in each leg
Note: When using a mobile cart you will need to plug it in and turn on the power.
Site to Site Call
1
1. Tap Call.
2. Tap in the search/dial field and enter the 5 digit number using the keypad.
3. Tap either of the green Call buttons to connect.
Far End Control Site to Site/Layout multi-site
Site to Site
• Tap Participants
• Adjust the other site's camera using the pan/tilt arrows and zoom +/-. Tap . . . .
outside the controls to return to near end (Fig 2).
(Note: This only applies if the other site has a remotely controllable camera - the
DX80 has a fixed camera along with some other types of equipment.)
Multi-site
The default layout is shown on the right. Other layout options
may be selected by the host/presenter when booking an event.
rev 04Apr2019
2
Fig 1
, tap the participant, then tap Camera. (Fig 1)
www.mbtelehealth.ca
Service Desk 204-940-8500 Option 4, Option 1
or toll-free 1-866-999-9698 Option 4, Option 1
Camera with privacy shutter,
turn counter-clockwise to
shut and clockwise to open.
Microphone mute button,
loudspeaker volume controls
and USB socket are on the
side of the unit.
Power On/Off
Make a Call
3
Fig 2
Quick Reference Guide
DX80 Touchscreen
Switch between computer monitor and
video screen by tapping the screen.
(When using as a desktop unit: if you
do not see the menu items along the
bottom of the screen, this may indicate
that the monitor is in sleep mode.
Move the mouse or press a key on the
keyboard to wake it up.)
The Home screen should always be
displayed prior to connecting to a site;
if not, this may mean that a previous
call was not disconnected. If you do
not see the Home screen, press End to
disconnect prior to connecting your call.
Out of Province Call
1. Tap Call.
2. Tap in the search/dial field and enter the .
phone number using the keypad.
3. Tap Call to connect.
Multi-Site Call
You will be automatically connected (see
note on back)
Press End to disconnect at the end of
every call (Site to Site and Multi-site).
Selfview options
1. Tap Selfview to turn it on and
off. Ensure you are visible so the other
site can see you.
2. Tap and hold the selfview image to see
available positions on the screen.
3. Drag to the desired location and
release.
1
2
Page 1 of 2