Conference Farendcontrol Signalcapability; Conference Farendmessage Mode; Conference Maxreceivecallrate; Conference Maxtotalreceivecallrate - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Conference FarEndControl SignalCapability

Define the far end control (H.224) signal capability mode.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Disable the far end control signal capability.
On: Enable the far end control signal capability.

Conference FarEndMessage Mode

Toggle whether it is allowed to send data between two devices in a point-to-point call,
for use with control systems or macros. Works with SIP calls only. This setting will enable/
disable the use of the xCommand Call FarEndMessage Send command.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: It is not possible to send messages between two devices.
On: It is possible to send messages between two devices in a point-to-point call.

Conference MaxReceiveCallRate

Define the maximum receive bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalReceiveCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 3072
Value space: Integer (64..3072)
The maximum receive call rate (kbps).
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Conference MaxTransmitCallRate

Define the maximum transmit bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalTransmitCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 3072
Value space: Integer (64..3072)
The maximum transmitt call rate (kbps).

Conference MaxTotalReceiveCallRate

Define the maximum overall receive bit rate allowed. This product does not support multiple
simultaneous calls, so the total receive call rate will be the same as the receive bit rate for
one call (ref. Conference MaxReceiveCallRate setting).
Requires user role: ADMIN
Default value: 3072
Value space: Integer (64..3072)
The maximum receive call rate (kbps).

Conference MaxTotalTransmitCallRate

Define the maximum overall transmit bit rate allowed. This product does not support
multiple simultaneous calls, so the total transmit call rate will be the same as the transmit bit
rate for one call (ref. Conference MaxTransmitCallRate setting).
Requires user role: ADMIN
Default value: 3072
Value space: Integer (64..3072)
The maximum transmit call rate (kbps).
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
92
Administrator Guide
Device settings Device settings Appendices