Cisco Webex DX70 Administrator's Manual page 75

Cisco Webex DX70 and DX80

Introduction
Factory reset the video conferencing device
We recommend that you back up the log files and configuration of the
device before you continue with the factory reset.
Factory reset DX80 using the mute and volume
buttons
Follow these steps to factory reset a DX80 on boot up. If the device is on,
press and hold the power button until the device shuts down before you
continue.
1. Locate the Mute and Volume up buttons.
2. Press and hold the Volume Up button and power on the device.
3. Release the Volume Up button when the
press the Mute button.
Wait while the device reverts to the default factory settings. The device
restarts automatically when finished. This may take a few minutes.
When the device has been successfully reset to factory settings, the
Setup assistant starts and you will see the Welcome screen.
Factory reset DX80 using the reset button
To use this method, the DX80 must be up and running.
1. Flip the connector cover up to uncover the connector panel at the rear
of the device.
2. Use the tip of a pen (or similar) to press the recessed reset button.
Hold the button for 1-2 seconds, until a notification Resetting to factory
settings shows on screen.
3. Wait while the device reverts to the default factory settings. The device
restarts automatically when finished. This may take a few minutes.
When the device has been successfully reset to factory settings, the
Setup assistant starts and you will see the Welcome screen.
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals
Mute button is lit red, then
Maintenance Maintenance
(page 3 of 4)
Right side seen
from the front
Mute
Volume up
Reset button (pin hole)
The recessed button can be quite difficult to use.
You should feel the button go down when pushed.
75
Administrator Guide
Device settings
Flip the connector cover up to
uncover the connector panel.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices