Operational Commands; Mounting And Wiring - Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual

Installation and Setup Guide
Mifare (Classic 32-bit and Desfire 56-bit) card type support.
l
Lid and off-wall tamper protection.
l
5.3.3

Operational Commands

User authorization
l
Arm/disarm (set/unset), and reset
l
View faults, troubles, and alarms
l
Bypass zones
l
Emergency buttons (panic, medical, and fire emergency; configurable per
l
area)
View and operate other areas
l
View activity log
l
View zone status
l
Run zone walk test, siren test.
l

Note
Besides using the keypad, the customer can arm/disarm the system
using the mobile app, via Visual Management in MAXPRO Cloud, or
automatically using Schedules in MAXPRO Cloud.
5.3.4

Mounting and Wiring

UL
For CAN/ULC-S304 compliance, install the keypad so that the system
status (armed/disarmed, status LED) is not visible from outside the
protected premise.

Note
For details on using the optional keypad wall mounting plate, see
Using the Optional Wall Mounting Plate on page 63.
To mount and wire the keypad, proceed as follows:
1. Find a flat, vertical surface in a convenient location.
60
Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
800-23044 Rev. A draft_11